Compool Cp3810 Instructions d'exploitation télécharger pdf (Page 32)

Compool Cp3810

Follow Programming example, set START TIME to 0:00 hours. Set RUN TIME to the number

of Hour/Minutes before equipment should Time-out.

Note

If the RUN TIME is set for 24 hours, manually activated equipment will run continuously

until manually turned off.

Programming a Once-only

The Once-only program is used to start the spa after a few hours, for example, you would like

to have the spa start in 2 hours. Once the program executes, it is automatically erased.

Follow the programming example above, enter the time the Spa should start (START TIME)

and set the RUN TIME to 0:00.

Canceling Programs

• To cancel all of the programs

1. Press the Program key. The Display will show a row of blinking icons located

immediately above the eight Equipment keys.

2. Press and hold down the Cancel key for 5 seconds. After 5 seconds, a continuous alarm

will sound (until you release the Cancel key), indicating that all of the programs have been

erased.

3. Press the Program key to end.

• To cancel an individual program

1. When programming or reviewing a program, pressing the Cancel key will return the

START TIME and RUN TIME to “0:00”.

Setting the Time of Day

To set the TIME OF DAY, press the Hours/Minutes key to set correct time. Pay attention to the

AM/PM symbol.

Remote Control key

It is possible to disable the Spa-side Remote from your Control Panel by pressing the Remote

Control key. The key is located behind the right-side door of the Control Panel. If the status

lamp is on, the Spa-side Remote is operational. If the status lamp is off, the Spa-side Remote

is disabled.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 42 43

Pas de commentaire

Compool Cp3810 Instructions d'exploitation Page 32